Brother HL-Series Technical Reference Manual page 261

Revision C 16/01/96
(2) Bar Code Style, Expanded Character shading, Line Block Drawing & Box
Drawing Shading
Ÿ
Bar Code Style
n = "s0" or "S0"
n = "s1" or "S1"
n = "s3" or "S3"
This parameter selects the bar code style as above. When the EAN 8, EAN 13, or UPC-A
bar code mode is selected, this bar code style parameter is ignored.
Ÿ
Expanded Character shading
"S" 0 = White
eg. "S" n1 n2
Ÿ
Line Block Drawing & Box Drawing Shading
"S" 1 = Black
(3) Bar Code Scaling (Width only)
n = "mnnn" or "Mnnn" (nnn = 0 ~ 32767)
This parameter specifies the bar code scaling of barcord width. The unit of "nnn" is %. The
default value is m100 (100%).
(4) Bar Code Human Readable Line On or Off
n = "r0" or "R0"
n = "r1" or "R1"
Default: Human readable line ON, when the following barcode types are selected.
Default: Human readable line OFF
This parameter specifies whether or not the printer prints the human readable line below the
bar code. Human readable characters are always printed with OCR-B font of 10 pitch, and
3 : 1 (default)
2 : 1
2.5 : 1
1 = Black
2 = Vertical stripes
3 = Horizontal stripes
4 = Cross hatch
n1 = Background fill pattern
n2 = Foreground fill pattern
If "S" is followed by only one parameter, the parameter is a foreground fill pattern.
2 = Vertical stripes
3 = Horizontal stripes
4 = Cross hatch
Human readable line OFF
Human readable line ON
(1) "T5" or "t5"
(2) "T6" or "t6"
(3) "T130" or "t130"
(4) "T131" or "t131"
All others
Chapter 7 "Bar Codes Control" - 3