Brother HL-Series Technical Reference Manual page 244

Revision C 16/01/96
Change emulation mode
EscCR<mode>
Ÿ
This command changes the printer emulation mode or performs a reset.
Ÿ
mode can be 'E' (Epson), 'P' or 'D' (Diablo), 'H' (Laserjet 4), 'I' (IBM Proprinter XL), 'AB'
(BR-Script Batch), 'AI' (BR-Script Interactive), 'GL' (HP-GL) or 'FD' (factory default).
Ÿ
On receiving this command the printer prints any remaining data and performs a page eject
(unless the current page is blank). The new emulation mode default settings come into effect,
except when the mode is set to 'FD'.
Ÿ
If you set the mode to 'FD' to reset the printer to its factory default settings, Laserjet 4 mode
(the factory default emulation mode) is selected and the Laserjet 4 factory default environment
is restored. For a list of the factory default settings see the sub-section "Factory default
environment" in the Chapter 2 "PCL" of this manual.
Ÿ
Selecting IBM Proprinter XL emulation with mode = 'I' causes the printer to be reset.
LPRINT CHR$(27); CHR$(13); CHR$(69); 'Change to Epson emulation
User Reset
EscCR!#R (27)(13)(33)#(82)
Ÿ
# = 0, restores to the current user setting.
Ÿ
# = 1, restores to User settings 1.
Ÿ
# = 2, restores to User settings 2.
Paper Input Control
EscEMn
Ÿ
n = 0, paper is fed from manual paper feeder.
Ÿ
n = 1, paper is fed from the standard paper cassette.
Ÿ
n = 2, paper is fed from the optional lower paper cassette.
Ÿ
n = 3, printer ejects the sheet of paper.
(27)(13)mode
(27)(25)n <1Bh><19h>n
Chapter 6 " IBM Proprinter XL " - 8
<1Bh><0Dh>mode
<1Bh><0Dh><21h>#<52h>