Brother HL-Series Technical Reference Manual page 40

Revision C 16/01/96
Positioning the cursor
You can position the cursor anywhere on the logical page. In addition, the cursor position is automatically
changed when text or graphics are printed. You can either position the cursor using absolute PCL coordinate
values or position it relative to the current cursor position, using dots, decipoints or rows and columns as units. In
case of using dots, the units value is defined by the ESC & u # d command. The commands for positioning the
cursor are listed below.
Vertical positioning
Vertical cursor positioning in Rows
Esc&a#R
# = number of rows
• A plus or minus sign preceding the number of rows parameter indicates that the cursor is to be positioned
relative to its current position. A signed positive parameter value signifies that the cursor is to be repositioned
vertically downwards on the page, a negative value means that it will be moved upwards.
• An unsigned number as the parameter signifies that the vertical repositioning is absolute - the cursor will be
repositioned the specified number of rows below the top margin, the PCL coordinate system's x-axis.
• The parameter value can have up to two decimal places.
• The cursor's horizontal position remains unchanged.
• If you attempt to move the cursor to a position that is outside the boundaries of the logical page, the cursor will
be positioned at either the top or bottom of the logical page as appropriate.
Units
Esc*p#Y
# = number of units
• Units value is defined by the Esc & u # D command.
• A plus or minus sign preceding the number of dots parameter indicates that the cursor is to be positioned
relative to its current position. A signed positive parameter value signifies that the cursor is to be repositioned
vertically downwards on the page, a negative value means that it will be moved upwards.
• An unsigned number as the parameter signifies that the vertical repositioning is absolute - the cursor will be
repositioned the specified number of dots below the top margin, the PCL coordinate system's x-axis.
• The cursor's horizontal position remains unchanged.
• If you attempt to move the cursor to a position that is outside the boundaries of the logical page, the cursor will
be positioned at either the top or bottom of the logical page as appropriate.
(27)(38)(97)#(82)
(27)(38)(112)#(89)
Chapter 2 "PCL" - 25
<1Bh><26h><61h>#<52h>
<1Bh><26h><70h>#<79h>