Brother HL-Series Technical Reference Manual page 108

Revision C 16/01/96
Execute data
The data saved in the PCMCIA card by using Printer's control panel "SAVE DATA" function can be printed by
the following command. It is also printed by the operation of Printer control panel.
EscCR!#E (27)(13)(33)#(69)
• # indicates the DATA ID.
• Execute the data which is saved in the flash memory card or Hard Disk card.
• The printer uses the current environment when this command is executed.
• During execiting the data, it is possible to change the emulation or reset the printer.
• If this command is included on the last of the data which is saved by "SAVE DATA" operation from the
printer's control panel, the printer enters the permanent roop so that the saved data such as DEMO printing
keeps printing. To stop it, press the RESET key on the printer's control panel. This function is available only
for the Flash ROM card.
<1Bh><0Dh><21h>#<45h>
Chapter 2 "PCL" - 93