Brother HL-Series Technical Reference Manual page 84

Revision C 16/01/96
Set source transparency
Esc*v#N
• This command sets the source image transparency.
• # is either 0 or 1. Set # to 0 to select transparent mode, and to 1 to specify opaque mode.
• Transparent mode means that parts of the destination image will be visible through the white space areas of the
source image when the source image has been printed on top of the destination image.
• Opaque mode means that parts the destination image will not be visible through the white space areas of the
source image when the source image has been printed on top of the destination image.
For example
With transparent
source image
(27)(42)(118)#(78)
Pattern
Source image
Destination image
Chapter 2 "PCL" - 69
<1Bh><2Ah><76h>#<4Eh>
Possible results
With opaque
source image