Revision C 16/01/96
Cancel graphics mode
Esc4
This command turns off graphics mode.
LPRINT CHR$(27); CHR$(52); 'Turn graphics mode off
Enable printer
DC1
The printer ignores this command.
Disable printer
DC3
This command disables the printer, preventing it from accepting or printing any data.
LPRINT CHR$(19); 'Put printer off-line
Change emulation mode / reset printer
EscCR<mode>
This command enables you to switch emulation mode or to reset the printer.
Any remaining pages are printed out when this command is invoked.
Change emulation mode by setting mode to the appropriate letter or pair of letters. Set mode to 'E' to
switch to Epson mode, 'H' to switch to Laserjet 4 mode, 'A B' to switch to BR-Script Batch mode, 'A
I' to switch to BR-Script Interactive mode, 'G L' to switch to HP-GL mode, 'I' to switch to IBM
Proprinter XL mode, 'FD' to switch to Laserjet 4 mode and reset the printer to its factory default
settings.
If you set mode to 'D' in Diablo mode, a printer reset is performed.
If you set mode to 'P' in either Diablo mode, a printer reset is performed.
The newly selected emulations default settings are restored, except when mode is set to 'FD'.
If you set mode to 'FD' to reset the printer to its factory default settings, LaserJet 4 mode (the factory
default emulation mode) is selected and the Laserjet 4 factory default environment is restored. For a
list of the factory default settings see the sub-section "Factory default environment" in "Chapter 2 -
PCL" of this manual.
LPRINT CHR$(27); CHR$(13); CHR$(73); 'Change to IBM Proprinter
mode
(27)(52)
<1Bh><34h>
(17)
<11h>
(19)
<13h>
(27)(13)mode
Chapter 4 "Diablo 630" - 11
<IBh><0Dh>mode