Brother HL-Series Technical Reference Manual page 319

Revision C 16/01/96
DI - Absolute Direction
DI [ run , rise ] [;]
run : X direction component
rise : Y direction component
• This command determines the direction in which subsequent labels will be printed.
rise
•
run
gives the tangent of the angle between the base line of a label's characters and the horizontal.
• run is equivalent to cos θ and rise is equivalent to sin θ.
• Values for run and rise are clamped real numbers.
• When you issue a DI instruction the carriage return point is set to the current pen location.
• The instruction is ignored if run and rise are both 0.
• Any text path that you set with the DV instruction will combine with the current printing direction to
determine the layout of characters on the page.
• If you omit the parameters the printing direction is horizontal.
• The label direction which is specified by this command is not affected by changes in the location of P1 and
P2.
10 ' -Absolute Direction -
20 WIDTH "LPT1:", 255
30 LPRINT CHR$(27); "E";
40 LPRINT CHR$(27); "%0B";
50 LPRINT "IN;SP1;";
60 DEG = -45
70 RAD = 3.1416 / 180 * DEG
80 LPRINT "IN;SP2;PA3050,4450;"
90 LPRINT "DT";"
100 LPRINT "DT0,2;LB_*_1988#"; "DI2,2;LB_*_1989#";
110 LPRINT "DT2,0;LB_*_1990#"; "DI2,-2;LB_*_1991#";
120 LPRINT "DT0,-2;LB_*_1992#"; "DI-2,-2;LB_*_1993#";
130 LPRINT "DT-2,0;LB_*_1994#"; "DI-2,2;LB_*_1995#";
140 LPRINT "PA3500,5350;DI", COS(0),SIN(0); "LB_*_2000"; CHR$(13); "#";
150 LPRINT "DI", COS(RAD); SIN(RAD); "LB_RETURN POINT"; CHR$(13); "#";
160 LPRINT CHR$(27); "%0A";
170 LPRINT CHR$(27); "E";
180 END
<sample 54>
tan θ =
rise
θ
run
Chapter 8 "HP-GL2" 53
θ
sin
θ
cos