System Operations - kozy heat Jordan Jor-30 Installation And Operation Manual

INITIALIZING THE SYSTEM FOR THE FIRST TIME
1. Move slider switch on receiver to OFF position.
2. Install 4 AA batteries (included in components packet) into receiver battery
bay.
3. Using the end of a paper clip, or other similar object, press button through
hole marked PRG on receiver front cover. Receiver will 'beep' three (3)
times to indicate it is ready to synchronize with a transmitter.
4. Install 3 AAA batteries (included in components packet) into transmitter
battery bay (located on base of transmitter). Push the ON button. The
receiver will beep four (4) times to indicate the transmitter's command is
accepted and set to the particular code of that transmitter.
5. Push OFF button on transmitter. The receiver will 'beep' two (2) times to
indicate the transmitter's command is again accepted.
6. Move slider switch to REMOTE position.
7. Turn On fan control module, switching to ON ( | ) position.
8. The system is now initialized.
NOTE This procedure must be performed every time batteries are replaced in Receiver or Transmitter.
TEMPERATURE DISPLAY
With the system in OFF position, press Thermostat Key and Mode Key at the
same time to change from degrees F to C. Look at transmitter LCD screen to
verify that C or F is visible on right side of Room Temperature display.
TURN ON THE APPLIANCE
Press ON/OFF key on transmitter. The display will show all active icons on the screen. A single 'beep' from receiver will confirm
reception of the command.
TURN OFF THE APPLIANCE
Press ON/OFF key on transmitter. The display will show only room temperature and icon on the screen. A single 'beep' from receiver will
confirm reception of the command.
SYSTEM OPERATION
7
Figure 7a
Figure 7b