Specifying Network Settings; Network Settings; Basic Settings; Parameters - Konica Minolta bizhub C200 Network Administration Manual

Hide thumbs Also See for bizhub C200:
Table of Contents

Advertisement

Specifying network settings

2.3
Specifying network settings
2.3.1

Network Settings

Parameter

Basic Settings

DNS Settings
Machine Name
SMTP TX Settings
SMTP RX Settings
POP3 Settings
Scanner Settings
IP Relay Settings
RAW Port Number Set-
tings
2.3.2
Basic Settings

Parameters

Parameter
DHCP
IP Address
Subnet Mask
Gateway
Network Board Set
Note
After changing the settings for these parameters, the machine must be turned off, then on again.
bizhub C200
Description
Specify the address settings in order to use this machine in a TCP/IP network
environment.
Specify the host name and domain name in order to use a DNS server.
Specify the machine name in order to send scans and faxes.
Specify the settings necessary for transmitting with SMTP.
Specify the settings necessary for receiving with SMTP.
Specify the settings necessary for receiving with POP3.
Specify the settings necessary for sending/receiving scanned documents.
Specify the relay settings necessary for performing IP relay operations.
The RAW port number can be changed in order to perform Port 9100 printing.
Description
Select whether to automatically retrieve the IP address from the DHCP server or to specify
a fixed IP address.
Specify the IP address of the machine.
Specify only if "DHCP" is set to "IP Input".
Type in the subnet mask of the connected network.
Specify only if "DHCP" is set to "IP Input".
Type in the gateway address of the connected network.
Specify only if "DHCP" is set to "IP Input".
Select the transmission speed of the network board (LAN board). Normally, this is set to
"Auto".
Auto: The transmission speed is automatically selected by auto-negotiation.
100M-Full: The 100 Mbps, full-duplex mode is selected.
100M-Half: The 100 Mbps, half-duplex mode is selected.
10M-Full: The 10 Mbps, full-duplex mode is selected.
10M-Half: The 10 Mbps, half-duplex mode is selected.
2
Page
refer-
ence
p. 2-7
p. 2-10
p. 2-13
p. 2-13
p. 2-16
p. 2-20
p. 2-22
p. 2-30
p. 2-34
2-7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents