Ping (Packet Internet Groper) Confirmation; Power Failure Restart; Power Failure Transfer - Panasonic KX-TDE100 Feature Manual

13.1.9 PING (Packet Internet Groper) Confirmation

Description
It is possible for this PBX to confirm the connection of IP telephones, routers, and hubs within or outside the
private network using PING. The PBX will send an Internet Control Message Protocol (ICMP) echo request
through the PC programming terminal and receive an ICMP message confirming connection.
Conditions
•
This PBX performs PING as follows:
•
Test packet length: 56 bytes
•
Ping attempts: 5
•
Time out length: 1 second
•
Ping interval time: 1 second
PC Programming Manual References
2.6.18 Utility—Ping

13.1.10 Power Failure Restart

Description
When the electricity is turned back on, the PBX restarts, loads its stored data automatically, and logs the event
as a System Restart in the error log.
Conditions
•
In the event of a power failure, PBX memory is protected by a factory-installed lithium battery. There is no
memory loss except the memories of Automatic Callback Busy (Camp-on) (® 1.1.4 Automatic Callback
Busy (Camp-on)) and Call Park (® 3.1.7 Call Park).

13.1.11 Power Failure Transfer

Description
If the power supply to the PBX fails, specific single line telephones (SLTs) are automatically connected to
specific CO lines (Power Failure Connections). The PBX will switch from the current connections to the Power
Failure Connections, and all existing conversations will be disconnected.
Only CO line conversations handled by Power Failure Connections can be made during a power failure.
Conditions
[General]
•
Only CO line calls can be made during a power failure. All other features do not work.
[KX-TDE100/KX-TDE200]
•
The analog CO line cards, extension cards, and the number of PFT ports (ports which can be used for
Power Failure Connections) are as follows:
Document Version 2009-12
13.1.11 Power Failure Transfer
Feature Manual 219