Display Lock - Panasonic KX-TDE100 Feature Manual

a.
the total recording time or number of voice messages exceeds the limit.
b.
the number of voice messages for an extension exceeds the limit.
c.
the destination of a call has been changed more than once.
d.
the desired message box is already in use by another user.
e.
a call is received at an ICD Group, and the message box of the first extension assigned to that group
is not available, or no extension is assigned as the first member of the group.
•
This feature does not answer calls that are forwarded using the Call Forwarding by QSIG feature (®
13.1.22 Private Network Features—QSIG—CF (Call Forwarding)).
•

Display Lock

A display PT user can lock the SVM Log display to prevent the user's information from being viewed and
voice messages from being played back at any extension through personal programming (Display Lock).
In this case, the Incoming/Outgoing Call Log displays and the Personal Speed Dialing number display are
also locked. An extension personal identification number (PIN) (® 5.1.6 Extension PIN (Personal
Identification Number)) is required to lock/unlock the display.
•
Accessing the Message Box of Another Extension
Listening to voice messages left by callers using a Message button for another extension is available only
when voice messages have been left in the message box.
•
Moving From SVM to DISA
When a call is answered by SVM but the caller wants to call another extension instead of leaving a
message, it is possible to access DISA (DISA OGM 01 will be played) by dialing the Operator Call feature
number. This allows the caller to call another extension via DISA or access the DISA AA service. The OGM
feature for the card/block to which the SVM mailbox belongs must be enabled via system programming.
[Recording Greeting Messages]
•
If an extension user tries to record a new greeting message to his message box when the total recording
time or number of messages has reached its limit, the user will hear a reorder tone.
•
It is not recommended to record music when creating a greeting message.
[SVM Remote Access from CO Line]
•
Whether Walking COS is available or not can be set through system programming.
If the PBX uses analog CO lines without the CPC service, it is strongly recommended to prohibit Walking
COS access. If an extension user who is accessing his message box through an analog line goes on-hook
while the voice messages are being played, the line will remain connected until all voice messages finish
playing. This is because a reorder tone cannot be detected from an analog line while playing voice
messages.
•
The first digit of the Walking COS feature number must be entered before the greeting message finishes
playing.
•
When accessing SVM through a CO line, it is possible to change message boxes (e.g., to leave a message
in another user's message box after listening to one's own messages). However, a user can only access
the message boxes of other extensions assigned to the same card/block. For example, if the user accesses
a message box belonging to card/block 1 first, then the user can only access the message boxes of other
extensions belonging to card/block 1. If the user tries to access the message box of another extension
belonging to a different card, the user will hear a reorder tone. While a reorder tone is heard, it is possible
to retry another call by pressing "
Installation Manual References
KX-TDE100/KX-TDE200
3.3.1 IPCMPR Card
3.7.1 OPB3 Card (KX-TDA0190)
3.7.6 ESVM4 Card (KX-TDA0194)
Document Version 2009-12
".
16.1.8 SVM (Simplified Voice Message)
Feature Manual 309