Multiple Communication Result Report - Canon iR3530 Manual

Multiple Communication Result Report

This report is used to check whether documents were sent successfully to the intended
destinations when a sequential broadcast transmission was performed.
You can set whether to automatically print a Multiple Communication Result Report after
sending documents. (See "TX Report," on p. 7-3.)
NOTE
• You can also print a Multi TX/RX Report with an image of the sent original attached to it. (See "TX
Report," on p. 7-3.)
• The default setting for printing the Multi TX is 'For Error Only'.
JOB NO.
The four digit number, that is automatically assigned when the document is accepted for sending, is
printed.
DEPT. ID
If Department ID Management is set, the Department ID is printed.
PGS.
9
The number of pages that were sent successfully to the destinations is printed.
TX/RX INCOMPLETE
The fax number and the name of the destination of an incomplete transmission are printed. If there is no
applicable destination, "_ _ _" is printed.
9-4
Report and List Samples