Installing The Vertical Stabilizer - Seagull Models Silence Twister Assembly Manual

SILENCE TWISTER
10) After the epoxy has fully cured, re-
move the masking tape or T-pins used to hold
the stabilizer in place. Carefully inspect the
glue joints. Use more epoxy to fill in any gaps
that may exist that were not filled previously
and clean up the excess using a paper towel
and rubbing alcohol.

INSTALLING THE VERTICAL STABILIZER.

Hinge.
1) Using a modeling knife, remove the
covering from over the precut hinge slot cut
into the lower rear portion of the tail at the fu-
selage.
Remove covering.
22
.
Epoxy.
Epoxy.
Instruction Manual.
2) While holding the vertical stabilizer
firmly in place, use a pen and draw a line on
each side of the vertical stabilizer where it
meets the top of the fuselage.
3) Slide the vertical stabilizer back in
place. Using a triangle, check to ensure that
the vertical stabilizer is aligned 90º to the hori-
zontal stabilizer.
Horizontal 90º
Stabilizer.
Fill epoxy.
Epoxy.
Vertical
Stabilizer.
Epoxy.