Installing The Spinner; Installing The Horizontal Stabilizer - Seagull Models Silence Twister Assembly Manual

Silence twister seagull models
Table of Contents

Advertisement

SILENCE TWISTER
Balsa stick.
Epoxy.
4) Locate the plywood battery tray to the
fuselage.
Battery.
5) Attach the speed control to the side of the
motor box using two-sided tape and tie wraps.
Connect the appropriate leads from the speed
control to the motor. Make sure the leads will
not interfere with the operation of the motor.
speed control.
20
.
140mm.
Tie wraps.
Instruction Manual.

INSTALLING THE SPINNER.

Install the spinner backplate, propeller and
spinner cone.
The propeller should not touch any part
of the spinner cone. If it does, use a
sharp modeling knife and carefully trim away
the spinner cone where the propeller comes
in contact with it.

INSTALLING THE HORIZONTAL STABILIZER.

1) Using a ruler and a pen, locate the
centerline of the horizontal stabilizer, at the
trailing edge, and place a mark. Use a triangle
and extend this mark, from back to front,
across the top of the stabilizer. Also extend
this mark down the back of the trailing edge of
the stabilizer.
2) Using a modeling knife, carefully remove
the covering at mounting slot of horizontal
stabilizer.
Draw center line.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Silence twister ms140

Table of Contents