5
Installing the Exhaust Guard
(CE Only)
Parts needed for this procedure:
1
Exhaust guard
4
Self-tapping screw
Procedure
1. Position the exhaust guard around the muffler while
aligning the mounting holes with the holes in the
frame (Figure 10).
Figure 10
1. Exhaust guard
2. Secure the exhaust guard to the frame with 4
self-tapping screws (Figure 10).
6
Adjusting the Lift Arms
No Parts Required
Procedure
1. Start the engine, raise the cutting units, and check to
ensure that the clearance between each lift arm and
the floor plate bracket is 0.18 to 0.32 inches (5 to
8 mm) (Figure 11).
cutting units removed for clarity
1. Lift arm
2. Floor plate bracket
If the clearance is not in this range, adjust it as
follows:
A. Back off the stop bolts (Figure 12).
1. Stop bolt
2. Lift arm
B. Back off the jam nut on the cylinder (Figure 13).
18
Figure 11
3. Clearance
Figure 12
3. Clearance