Comm. Setting - Konica Minolta Bizhub 162 Service Manual

7. Utility Mode
7.3.10

COMM. SETTING

A. TONE/PULSE
Functions/Use • This function can be used to specify the dialing system. If this function is not cor-
• There are two types of telephone dialing systems: tone dialing (PB) and pulse
Setting/Procedure • The default setting is "TONE".
B. LINE MONITOR
Functions/Use • This function can be used to set the volume when monitoring communication to
• Usual TX/ RX (Start)
• Usual TX/ RX (End)
• Using Speaker key (Start) : Just after pressing Speaker key.
• Using Speaker key (End) : Just after pressing Speaker key.
Setting/Procedure • The default setting is "LOW".
C. PSTN/PBX
Functions/Use • This function can be used to set whether the connected telephone wiring is a
• The connected wiring system can be set to either PSTN (Public Switched Tele-
Setting/Procedure • The default setting is "PSTN".
50
rectly set to the type of dialing system used, faxes cannot be sent. Select the
correct setting after checking which type of dialing system is used by your tele-
phone line.
dialing (DP10pps or DP20pps). Faxes cannot be sent if this machine is not set to
the system used by your telephone line. Select the correct setting after checking
which type of dialing system is used.
"TONE" : Tone line
PULSE 10pps : Pulse line of 10 pps
PULSE 20pps : Pulse line of 20 pps
"HIGH", "LOW" or "OFF".
HIGE --- Usual TX/ RX : High, Usual SPEAKER key : High
"LOW" --- Usual TX/ RX : Low, Usual SPEAKER key : Low
OFF --- Usual TX/ RX : Off, Usual SPEAKER key : Low
public switched telephone network (PSTN) or a private branch exchange (PBX).
For a PBX system, the outside line access number (or extension number) must
be specified.
phone Network) or PBX (Private Branch Exchange). For a PBX system, the out-
side line access number (or extension number) must be specified. The outside
line access number (or extension number) is programmed in the [#] key.
"PSTN" : Public Switched Telephone Network
PBX : Private Branch Exchange
Field Service Ver. 1.0 Apr. 2005
: Pressing Start key following pressing ten-key.
Pressing Start key following pressing Speed dial.
Pressing One-touch key.
Pressing Redial key.
: After receiving V21 signal.