Konica Minolta Bizhub 162 Service Manual page 80

Field Service Ver. 1.0 Apr. 2005
9. Use the two screws to secure the gear to wire pulley 2.
NOTE
• Make sure that the cable pulley is doweled to the gear.
10. Mount the front and rear cable pulleys onto the shaft and install the shaft to the copier.
Rear Side
11. Fit two Bearings and snap on two C-rings.
6. Wind the cable on side A around
4035D115AA
7. Wind the cable on side B around
4035D116AA
8. Affix tape to secure the cable to wire
4035D117AA
NOTE
• Install the shaft as shown on the left.
Front Side
4035D515AA
wire pulley 1 four turns counterclock-
wise, starting with the slit at the bot-
tom in the front left of the pulley.
wire pulley 1 four turns clockwise,
starting with the slit at the top in the
rear left of the pulley.
pulley 1.
6. Other
51