Print All Of The Vps Parameters (Gprn); Program Version Display (Vers) - Panasonic KX-TVS90 Installation Manual

Notes
• The data terminal that you use must be equipped with communications software that
supports the Xmodem file transfer protocol. The command can be canceled by Typing
[\] before entering the sending mode. Once the sending mode has been selected, use
the cancel command of the communication software being used.
• If your data terminal supports a high speed, it is recommended that you LOAD at the
maximum speed of 38400 bps. First, change the RS-232C setting of the VPS (see
B7.1 RS-232C Parameters). Next, change the RS-232C setting of your data terminal
to the same speed.

7.2.9 Print All of the VPS Parameters (GPRN)

Use the GRPN command to print all VPS parameter settings (output to screen). Use Ctrl-C at
any time to stop printing.
Type GPRN, then Press RETURN.
$ GPRN
0: All Parameters
1: Mailbox Setting
2: Class of Service Setting
3: Port/Trunk Service Setting
4: Service Setting - Auto Attn. Setting
5: Service Setting - Custom Service Setting
6: Service Setting - Caller ID Call Routing
7: System Parameter Setting - System Group Assignment
8: System Parameter Setting - Time Service, Holiday, Daylight Saving Time
9: System Parameter Setting - Prompt Setting
10: System Parameter Setting - System Caller Name Announcement
11: System Parameter Setting - Others
12: Hardware Setting
13: System Reset Clear Parameter
Please select : =
Note
This command is only valid when in the ASCII TERMINAL mode.

7.2.10 Program Version Display (VERS)

Use the VERS command to display the version numbers of the flash memory and main ROM.
Type VERS, then Press RETURN.
$ VERS
V.P.S. PROGRAM VERSION
MAIN FLASH MEMORY : VP21AA (4.12)
MAIN ROM :
Installation Manual
SYSTEM MAINTENANCE AND TROUBLESHOOTING
VP01AA (2.01)
167