Panasonic KX-TVS90 Installation Manual page 282

SYSTEM ADMINISTRATOR'S GUIDE
Parameter
Paging Code
for Group 1-16
Paging Code
for All Groups
Other Parameters-Fax Management
You can program the VPS to automatically forward incoming fax calls to a fax extension. You
can specify a maximum of 2 fax extensions as the destination for the Automatic Fax Transfer.
If the main fax extension is not available to receive a fax, the VPS will forward the fax
transmission to the alternate fax extension.
To access the proper menu for Fax Management, follow the menu path as shown:
System Administration Top Menu-1-5-7-8
Parameter
Automatic
Transfer of
Incoming Fax
Call
Main Fax
Extension No.
Alternate Fax
Extension No.
282
Value Range
(Default)
Up to 12 digits Specifies the intercom paging access code required by
consisting of the PBX.
0-9, ,# for each
group
Note: The Intercom Paging Group Number available
(Group 1-8:
for each subscriber is determined on a COS-by-COS
331-338;
basis.
All Groups
[Group 17]: 33 )
Value Range
(Default)
1: Disable Enables or disables the Automatic Transfer of Incoming
2: Enable Fax Call Service.
(Disable)
Note: Automatic detection works for only the first 30s.
2-5 digits Specifies the main fax extension number.
(None)
2-5 digits Specifies the alternate fax extension number. When the
(None) main fax extension is busy or does not answer within the
specified "Fax No Answer Time", the VPS forwards the
fax call to the alternate fax extension.
Table 67
Description/Function
Table 68
Description/Function
Installation Manual