Panasonic KX-TVS90 Installation Manual page 290

SYSTEM ADMINISTRATOR'S GUIDE
Parameter
Integration
Mode
Extension
Number of
VPS Port 1-2
290
Value Range
(Default)
1. None Specifies the method of integrating the VPS with the
2. Inband PBX.
3. APT
1. None—Both PBX and VPS work independently,
4. DPT
(DPT)
2. Inband—The PBX sends touchtone codes to the VPS
3. APT—The VPS communicates with the PBX via the
4. DPT—The VPS communicates with the PBX via the
2-4 digits Specifies the extension number of each VPS port.
(Port 1-2: 165-
166) Note: Extension numbers of the VPS ports will
automatically be assigned when: (1) Auto Configuration
is executed, or (2) PBX type has been changed.
Table 74
Description/Function
without accessing information concerning the status
of the other.
to indicate the state of the call (busy, answered,
disconnect, etc.). Inband Integration improves the
VPS performance because call state recognition is
faster than with standard call progress tone detection.
The PBX code for each call state must be set in the
Inband Signaling Parameters. If PBX type is set to a
KX-T series telephone system, the Inband Signaling
Parameters will automatically default to the proper
codes. This is available with any of the following
Panasonic KX-T series telephone systems: T1232,
TA series, T96, T336, TD816, TD1232, TA1232,
TD308, and TD500.
APT interface. This is available only with Panasonic
KX-TA624.
DPT interface. This is available with any of the
following Panasonic KX-T series telephone systems:
TD816, TD1232, TA1232, TD308, and TD500.
Installation Manual