Error Log Display (Elog) - Panasonic KX-TVS90 Installation Manual

SYSTEM MAINTENANCE AND TROUBLESHOOTING

7.2.6 Error Log Display (ELOG)

Use the ELOG command to diagnose VPS problems. Selection of this command will display
an error log.
COM. Communication error between CPU and DSP
DATA Process error of voice data
MEM. Memory error
PRG. Program error in CPU card
R/W Read/Write error of Flash Memory
Type ELOG, then Press RETURN.
$ ELOG
Note
The following tables display and explain the errors that the system can identify.
CPU
CLOCK
FLASH
MEMORY
DSP*
DSP*
CPU
* = Port number (1-2)
162
DEVICE ERROR
1. CPU MEM-GET
2. CLOCK
3. FLASH DATA R/W (xx:yyyy)
MEMORY
4. DSP* SCAN
5. DSP* FIFO
6. CPU APPLICATION (x)
* = Port number (1-2)
Table 29 Device Error Log Indications
Indication
MEM-GET
DATA R/W (xx:yyyy) Flash Memory access error. If there is a sector that
SCAN
FIFO
APPLICATION (x)
TIME
JUL-14 2:00 PM
JUL-14 2:00 PM
JUL-14 2:00 PM
JUL-14 2:00 PM
JUL-14 2:00 PM
JUL-14 2:00 PM
Meaning
CPU card software memory acquisition error.
CPU card is short of memory temporarily because
of too much traffic.
Clock access error. Clock IC is out of order.
Check the hardware.
often causes errors, check the flash memory.
xx : IDE error code
yyyy : read/write error sector number
DSP-SCAN error. DSP is out of order. Check the
hardware.
DSP/FIFO error. During the system is handling
calls, there is something wrong with DSP and
FIFO memory temporarily.
Application error. While the system is handling
calls, temporary application error occurs.
x: port number
Installation Manual