Panasonic KX-TVS90 Installation Manual page 281

Parameter
Intercom
Paging
Sequence
Release for
Intercom
Paging
No Answer
Time for
Intercom
Paging
Announcement
Repeat Cycle
Intercom
Paging Retry
Installation Manual
Value Range
(Default)
Up to 12 digits con- Specifies the intercom paging sequence required by
the PBX. This can be programmed using up to 12 of
sisting of 0-9, , #
the following 8 letters and 12 dial codes.
and special codes
(FXW)
D: Disconnecting
F: Hook Flash
R: Ringback Tone Detection
S: Silence Detection
T: Dial Tone Detection
W: Wait for 1 s
X: Pager Dialing
A: Answer
1-9, 0, , #: Dial Codes
Up to 12 digits con- Specifies the intercom paging release code required by
the PBX. This can be programmed using up to 12 of
sisting of 0-9, , #
the 8 letters and 12 dial codes as specified above.
and special codes
(FW)
1-30 s Specifies the length of time (in seconds) the VPS must
(5) wait before concluding Intercom Paging when there is
no answer.
The VPS will return to the caller if the paged party
does not respond before this timer expires.
1-3 times Specifies the number of times to announce the
(1) intercom page.
Example:
"I have a call for (mailbox owner's name)".
1-10 times Specifies the number of times to retry paging when the
(2) paging destination is busy or if there is no answer.
Note: This setting applies only when the subscriber has
enabled "Intercom Paging" in Incomplete Call
Handling Status.
SYSTEM ADMINISTRATOR'S GUIDE
Table 67
Description/Function
281