Installing Nextscale System In Other Racks - IBM NeXtScale System Planning And Implementation Manual

Front and rear cable access openings at the top and bottom of the rack, as
indicated by arrows in Figure 5-8 on page 129. The top cable access opening
doors slide to restrict the size of the opening. For most effective use, do not
tightly bundle cable that is passing through these openings. Instead, use the
doors to flatten them in to a narrow row.
Pre-drilled holes in the top of the rack for mounting third-party cable trays to
the top of the rack.
The part numbers for the racks are listed in Table 5-6.
Table 5-6 Enterprise V2 Dynamic Rack part numbers
Part Number
93634PX
93634EX
For more information about this rack, see the Installation Guide, which available
at this website:
http://www.ibm.com/support/entry/portal/docdisplay?lndocid=migr-5089535

5.4.2 Installing NeXtScale System in other racks

It is possible to install NeXtScale System chassis in other racks. The IBM
NeXtScale n1200 Enclosure can be installed in most industry-standard, four-post
server racks. Figure 5-10 on page 132 shows the dimensions of the IBM
NeXtScale n1200 Enclosure and included rail kit.
Description
IBM 42U 1100 mm Enterprise V2 Dynamic Rack
IBM 42U 1100 mm Enterprise V2 Dynamic Expansions Rack
Chapter 5. Rack planning
131