Evinrude E-tec 75 HP Service Manual page 253

Install the tilt limit switch and retainer on the swivel
bracket. Torque screws to 40 to 50 in. lbs. (4.5 to
5.7 N·m).
1
1. Tilt limit switch
2. Retainer
Route the trim sender wires through the braided
tube, and install the sender unit in the port stern
bracket.
Install the upper and lower steering shaft bushings
and new seals in the swivel bracket. Both seal lips
face out.
•
Coat the outside surfaces of seals with Gasket
Sealing Compound.
•
Coat the bushings and seal lips with Triple-
Guard grease.
2
Coat tilt tube bushings with Triple-Guard grease
30758
and, if removed, install them in the swivel bracket.
Place the swivel bracket between the stern brack-
ets and install the anode.
30760
Install the tilt tube and tilt limit cam. Refer to TILT
TUBE on p. 242.
Install the steering shaft and thrust washer.
MIDSECTION
STERN BRACKET
30765 / 30764
30761
11
30735
253