Evinrude E-tec 75 HP Service Manual page 219

Oil the wrist pin bore and wrist pin. Push the wrist
pin part way through the top wrist pin hole.
Place connecting rod, with bearings, washers,
and tool, into the piston with the alignment dots
facing the top of the piston.
Install wrist pin through piston and connecting rod,
pushing bearing tool out through the piston.
Use Wrist Pin Cone, P/N 318600, and Driver,
P/N 318599, to install new wrist pin retaining rings
in each wrist pin hole. Gap of retaining ring faces
up, away from notch in piston.
002056
1
1. Gap of retaining ring
2. Notch in piston
Repeat steps for each piston.
Installing Pistons
When all pistons and connecting rods are assem-
002057
bled, install piston ring sets. Be sure rings are
installed in the cylinder used to test ring end gap.
IMPORTANT:
around dowel pin.
POWERHEAD
ASSEMBLY
Be sure gap of ring fits squarely
002058
2
002050
10
002048
219