MIDSECTION
STERN BRACKET
Remove the steering shaft and thrust washer. It
may be necessary to tap the steering shaft out
using a wood dowel and mallet.
Pry out upper and lower steering shaft seals and
discard. Remove the upper and lower steering
shaft bushings.
Remove the tilt tube. Refer to TILT TUBE on
p. 242.
Remove the two tilt tube washers.
250
Remove the anode.
1. Anode
Remove the swivel bracket. Inspect and, if neces-
30735
sary, replace the tilt tube bushings.
1. Tilt tube bushing
30765 / 30764
Remove the trim sender unit from the port stern
bracket and pull its wires through the braided
tube.
30763
1
30762
1
30761
30760