Install the water tube through the top of the inner
exhaust housing and align as shown:
Place a new gasket between the inner exhaust
housing and the adapter housing. Apply Ultra
Lock to the screws. Install the three lower screws
and three upper screws and torque to 60 to 84 in.
lbs. (7 to 9.5 N·m).
1
1. Lower inner exhaust housing screws
1
1. Upper inner exhaust housing screws
Apply Adhesive 847 to the bottom flange of the
adapter/inner exhaust housing. Install a new seal.
Apply Triple-Guard grease to outer surface of
seal.
1
001982
1. Seal
2. Bottom flange
Clean and degrease the adapter housing and
outer exhaust housing mating surfaces with
Cleaning Solvent. Apply Gel-Seal II sealant to the
adapter flange of the exhaust housing.
1
001974
1
Place the adapter/inner exhaust housing into the
exhaust housing. Guide the water tube through
001975
MIDSECTION
EXHAUST HOUSING
2
New
001983
247
11