Evinrude E-tec 75 HP Service Manual page 232

POWERHEAD
INSTALLATION
1. Top, rear cover screw
Install air silencer and tighten screw.
232
IMPORTANT:
before returning outboard to service:
•
Index all spark plugs. Refer to Spark Plug
Indexing on p. 144.
•
Use the Evinrude Diagnostics Software pro-
1
gram to initiate powerhead break-in. Refer to
Powerhead Break-In on p. 98.
•
Adjust timing pointer and check engine timing.
Refer to TIMING ADJUSTMENTS on p. 142.
•
Run outboard and check for water, fuel, or oil
leaks.
•
Confirm that engine reaches correct operating
002150
temperature and does not overheat.
Perform the following procedures