Evinrude E-tec 75 HP Service Manual page 231

Connect the power trim connectors.
Installation of lower motor covers will be greatly
simplified if the following steps are performed in
sequence:
•
Place starboard cover on outboard and route
fuel hose and battery cable through grommet
notch.
•
Insert trim cable grommet into port side cover.
•
Connect trim/tilt switch connector.
•
Bundle trim wires below starter and in front of
capacitor as shown.
•
Place port side cover into position on outboard.
1
2
3
1. Battery cable
2. Trim cable grommet
3. Trim connector bundle
4. Trim/tilt switch connector
Start the screw above the exhaust relief grommet
first. Tighten just enough to hold the grommet in
place.
002152
1. Start this screw first
2. Exhaust relief grommet
Start the top front screw next and draw cover
halves together.
1
1. Start this screw second
4
Install remaining cover screws and tighten all
screws to 24 to 36 in. lbs. (3 to 4 N·m).
002156
1
1. Cover screws
POWERHEAD
INSTALLATION
1
2
002157
002165
10
1
002149
231