Evinrude E-tec 75 HP Service Manual page 206

POWERHEAD
REMOVAL
Remove six retaining screws and exhaust relief
muffler.
Install Lifting Fixture, P/N 396748, on flywheel and
seat the three screws completely.
IMPORTANT:
Be sure to use only the 1 1/8 in.
(short) screws, P/N 398067, included with the tool
to avoid damage to electronic components under
the flywheel.
1
1. Lifting fixture
2. 1 1/8 in. screws
Fasten appropriate chain hook to eye of tool and
support weight of powerhead with hoist.
206
Remove the small powerhead screw at rear.
1. Rear small powerhead screw
002159
Remove remaining four small powerhead screws,
six large powerhead screws, and the upper mount
screws.
3
1
2
1. Small powerhead screws
2. Large powerhead screws
3. Upper mount screws
Use a suitable tool to carefully separate the pow-
erhead from exhaust housing.
002098
1
002160
1
2
002153
002161