Evinrude E-tec 75 HP Service Manual page 172

FUEL SYSTEM
FUEL COMPONENT SERVICING
Thread adaptor and stud into face of injector. Hold
mounting cup securely. Work slide hammer to
separate injector from mount housing.
Remove adaptor from injector. Remove crush ring
and O-rings from injector. Inspect and clean injec-
tor filter. Install new crush ring and O-rings. Lubri-
cate O-rings with STP
1. Adaptor
1. Crush ring
2. O-rings
172
†
Oil Treatment.
Reinstall injector into mount housing. Press on
injector face until injector seats in mount housing.
002345
Installation
IMPORTANT:
the correct cylinder by serial number. Improper
injector installation can result in outboard failure.
Installation of replacement injectors requires the
use of diagnostic software and coefficient data
supplied with all replacement injectors on 3.5 in.
floppy disk.
1
002196
2
IMPORTANT:
1
moving the coefficient data file to the "PDS_data"
folder on a PC and then a "hotsync" of the PDA
before the injector serial number can be reviewed
on the PDA. Refer to the electronic user's guide
on the Engine Diagnostics CD.
002317
All injectors must be installed in
PDA software requires manually
002318
005157