Updating Firmware Using Gui Configurator - Extron electronics TLP 1000MV User Manual

3.
From the same site, download the firmware for the TouchLink panel. Click the
Download
Figure 23.
4.
Navigate to the TLP 1000MV or TLP 1000TV firmware and click
This downloads the firmware to your computer. Note the folder in which the firmware
file is saved.
5.
Open the Extron Firmware Loader by clicking on the desktop icon.
6. Select
7.
Select
8. Enter the IP address for the TLP 1000, a Telnet port number (this will usually be 23),
and a password. Click
9. In the New Firmware File "Path" pane, navigate to the file that was saved in step 4.
Click the
or TLP 1000TV listed in the device pane.
10.
Click Begin
When the Total Progress bar shows "Completed", select
exit Firmware Loader.

Updating Firmware Using GUI Configurator

1. Set up the computer and touchpanel as described in steps 1 and 2 in the previous
section
install the Extron Firmware Loader
Software").
2. Find the firmware on the Extron website and download it to your computer, as
described in steps 4 and 5 in the previous section.
3.
Open GUI Configurator. Open Firmware Loader by clicking on
Manager...
Figure 24.
4. Follow steps 7 to 10 from the previous section,
Firmware
tab on the Extron home page and select the
Extron Web Page — Download Center
or
TLP 1000MV TLP 1000TV
from the
TCP/IP Connection Method
.
Connect
button. The main Firmware Loader screen opens with the TLP 1000MV
Add
. The firmware transfer begins and takes approximately three minutes.
("Updating firmware using Extron Firmware
in the menu.
Tools
Opening Firmware Loader from GUI Configurator
Loader".
TLP 1000MV and TLP 1000TV • Configuration Software
Firmware
from the drop-down menu.
Device
drop-down menu.
from the
Exit
Loader"). If necessary,
utility onto the computer (see "Installing the
Firmware Update
"Updating Firmware Using Extron
option.
Download .
menu to
File
22