Table of Contents
Advertisement
50 Controls and Indicators
Time and Date Indicator
A time and date indicator may be found on the upper left-hand side corner of the screen. The
availability of this indicator is based on the chassis on which the body is mounted. If the chassis
provides real-time clock information through the J1939 bus, time and date will appear on the screen.
To set the Time and Date indicator, go to the Main Menu and choose Time Adjust.
Main Menu
To access the Main Menu, press the far left button when the Main page is displayed.
When the Main Menu is displayed, you can have access to the following sections:
I/O Status
Program Version
Pump Usage (optional)
Auto-Dump (optional)
Time Adjust (available according to chassis)
Displayed in the lower center of the screen is an indicator that monitors traffic on the network. This
indicator is called Network Load, and it shows values that reflect such traffic.
: The higher the network load value is, the heavier the traffic is on the network. Also, the lower
N
OTE
the network load value is, the less the traffic is on the network.
To exit this page and return to the Main page, press "Esc". To choose a section from the Main Menu,
highlight the desired section using the up/down arrows and press the "OK" button.
I/O Status
In this section, you will find helpful information to troubleshoot body-related problems that you may
face during your day-to-day tasks. These problems can be of any nature, from hydraulic to
mechanical, electrical or pneumatic.
Select the control module corresponding to the part of the truck that needs to be checked.
For example, if you want to check all functions that are found in the cab, choose module #10. For all
functions that pertain to the chassis, choose module #20, etc.
To choose a particular module, use the up/down arrows to select it and press "OK".
: Pressing "OK" can be done two ways: either press the far right button or the "OK" button.
N
OTE
Press "Esc" to return to the preceding page.
Advertisement
Table of Contents
