Packer Blade Packing Position - Wittke StRLight Operator's Manual

34 Safety
If the hydraulic system is still operative, the Side Access Door proximity switch may need to be
4.
adjusted or replaced. Refer to the Limit and Proximity Switches section in the Maintenance
Manual.

Packer Blade Packing Position

Successful completion of this test ensures that the packer blade does not move beyond the mid-body
point during the pack cycle.
For this test, do the following:
Ensure the tailgate is fully closed.
1.
Press the Pack button (see Figure 3-25) until the packer blade reaches the end of its stroke.
2.
Press the Stop button (see Figure 3-24).
3.
Check that the upper section of the packer blade is 4 inches from the mid-body breaker bar.
4.
If the packer blade packs beyond that point, the packer Fully Extended proximity switch may
5.
need to be adjusted or replaced. Refer to the Limit and Proximity Switches section in the
Maintenance Manual.
: The packer blade must not pack beyond the point located 4 inches from the mid-body breaker
N
OTE
bar, unless the tailgate is fully open. Severe damage may result.