Obey speed restrictions and regulations if driving from the right-hand side.
Overheight Caution
In some locations, the front loader may be overheight when the arms are in the full up travel position.
Consult local regulations or confer with your supervisor if unsure.
: Before passing under an overpass, be aware of the required clearance.
N
OTE
Commercial Units when not in Collection Mode
To correctly position the arms, do the following:
Raise the arms until they rest on the rubber bump stops (see Figure 4-8).
1.
Figure 4-8
Rubber bump stop
: Be aware of the required overhead clearance at all times.
N
OTE
Retract the forks fully until the Arms not Stowed indicator light on the console panel turns green
2.
(see Figure 3-15).
Close the top door (see Top Door Switches (Roof Open/Roof Close) on page 63).
3.
Turn off the hydraulic pump (see Pump Switch on page 57) to reduce the engine load between
4.
stops.
Operating the W
™ 81
ITTKE