Cleaning Of The W; Preparing The Unit Before Departure - Wittke StRLight Operator's Manual

Drive the unit slightly forward as the contained refuse is unloaded.
4.
Set the parking brake.
5.
Cycle the packer blade a few short strokes to remove any remaining refuse.
6.
Fully retract the packer.
7.
Press the Tailgate Close switch on the control panel (see Figure 3-15) and keep it pressed until
8.
the tailgate is fully closed and locked.
: As soon as the tailgate is closed and locked, the in-cab buzzer and back-up alarm will stop
N
OTE
sounding. Also, during the descending movement of the tailgate, both the Tailgate Open
switch and the Tailgate Close switch flash red. The Tailgate Close switch will turn green when
the tailgate reaches its fully closed and locked position.
Open the clean-out door (optional) to let any liquid waste drain away.
9.
Close the clean-out door.
10.

Cleaning of the W

In order to ensure the continued good working condition of the W
unit has to be cleaned after each working day.

Preparing the Unit Before Departure

To prepare the W
Retract the packer blade until it is close to the beginning of the hopper area.
1.
Close the tailgate until it is approximately 4 ft (1.2 m) from the tailgate seal.
2.
Set the tailgate safety prop (see Tailgate Safety Prop on page 28).
3.
Complete the lockout/tagout procedure (see Locking Out and Tagging Out the Vehicle on
4.
page 38).
™
ITTKE
™ for the clean-up process, proceed this way:
ITTKE
Operating the W
™ and its components, the
ITTKE
™ 91
ITTKE