Table of Contents
Advertisement
72 Operating the W
™
ITTKE
Tasks to be performed during daily visual inspection:
Ensure the engine is not running and the parking brake is set.
Ensure the cleanliness of lamps, safety decals, camera lenses, mirrors, windows, and the vehicle in
general.
Ensure that safety equipment is present (i.e. fire extinguisher, first aid kit).
Ensure there is no structural damage.
Ensure that body mounts to chassis are tight and that there are no cracks on it or on the structure
around it.
Ensure that there is no unusual wear, distortion, cracking, leaning, leaking on the vehicle.
Ensure that hydraulic oil level (sight gauge on tank) is as recommended (cylinders must be
collapsed).
Ensure that the hydraulic cylinders do not leak, and ensure mounting pins are secure.
Ensure the hydraulic tank shut-off valve is fully open.
Ensure there are no mechanical problems: structure, rollers, hinges, door locks, wear items, etc.
Report any defective system to maintenance personnel.
Ensure there are no leaks, cracks or other types of problems on the frame area, fuel tank, hydraulic
tank, air tanks (air tanks must be drained every day), cleaning trap and wheels.
Ensure the tailgate is fully closed and locked, BOTH tailgate safety pins are in place and rollers are
on main locking pins.
Once the visual inspection is over, you must start the engine to check if the systems are working
properly.
Starting the Vehicle
To start the W
Before starting the engine, check the following items:
1.
Transmission shifter is on neutral.
1 a.
Parking brake is on (see Parking Brake on page 69).
1 b.
Hydraulic system is off (see Pump Switch on page 57).
1 c.
Start the vehicle as stated in the chassis manufacturer's manual.
2.
Switch ON the pump to engage the hydraulic system (the air pressure has to be at a minimum of
3.
70 psi). See Figure 3-14.
Turn on all light switches.
4.
If required, move the truck to an appropriate area to perform daily inspection.
5.
Report any defective system to the maintenance personnel.
6.
Body Inspection Procedure
Exit the cab to continue your inspection. Bring a rag along to clean all accessible lights, labels, camera
lenses, etc. Check for mechanical problems: rollers, hinges, door locking mechanisms, wear items,
etc. Report any defective system to the maintenance personnel.
™:
ITTKE
Advertisement
Table of Contents
