Table of Contents
Advertisement
88 Operating the W
™
ITTKE
Packing Refuse Using the Pack Button
The packer blade should be cycled every time the contents of a container (or a carry can) are dumped
into the hopper.
To activate the packing cycle:
Turn on the hydraulic system (see Pump Switch on page 57).
1.
: When the side access door is open (see Figure 4-1), the hydraulic pump is disabled. This door
N
OTE
MUST therefore be closed properly in order for the hydraulic pump to be activated. The
Hopper Door Open indicator light on the control panel must also be green-lighted (see Hopper
Door Open Indicator Light on page 64).
Open the top door (see Top Door Switches (Roof Open/Roof Close) on page 63).
2.
: A reinforced roof (optional on S
N
OTE
packing with the roof closed.
I
:
The top door is only designed to prevent refuse from escaping the hopper during transport. It
MPORTANT
should not be closed during packing, except if a reinforced roof is installed. Serious damage may
result.
Press the Pack button to actuate the packer blade. See Pack Push-Button (green) on page 65.
3.
The packer should automatically complete a cycle then stop in its "home" position.
Packing Refuse Using the Auto-Packing Mode
To activate the packing cycle:
Turn on the hydraulic system (see Pump Switch on page 57).
1.
Open the top door (see Top Door Switches (Roof Open/Roof Close) on page 63).
2.
Turn on the Auto-Packing switch on the control panel (see Auto-Packing Switch (optional) on
3.
page 61).
: Lowering the arms activates the Auto-Packing cycle when the corresponding switch is
N
OTE
activated (green-lighted).
Turn off the Auto-Packing switch when this feature is no longer needed.
4.
™ units and standard on S
TARLIGHT
D
™ units) allows
UPER
UTY
Advertisement
Table of Contents
