Forks Width Switches (Optional); Speed-Up Switches (Optional) - Wittke StRLight Operator's Manual

62 Controls and Indicators

Forks Width Switches (optional)

These optional switches (see Figure 3-21) allow the operator to either increase or decrease the width
between both forks.
The upper switch is used to increase the width between both forks.
Press this switch and keep it pressed until the desired width is reached.
The lower switch is used to decrease the width between both forks.
Press this switch and keep it pressed until the desired width is reached.
Figure 3-21 Forks width switches
: If this optional feature is available on your unit, these switches are located on the control
N
OTE
panel.

Speed-Up Switches (optional)

These switches (see Figure 3-14) engage/disengage the optional speed-up feature which is used to
increase the engine speed up to 1500 RPM whenever a pack or an auto-pack cycle is initiated.
The upper switch is used to engage the speed-up function which increases the engine speed to
1500 RPM until disengaged.
Press this switch to engage the speed-up function (switch turns green).
Figure 3-22 Speed-up "ON"