Table of Contents
Advertisement
82 Operating the W
™
ITTKE
: Switch the hydraulic pump to OFF if you route destination is more than 1 mile (1.6 km) away.
N
OTE
Residential Units when not in Collection Mode
Driving a residential front loader when it is not in collection mode requires some special
considerations:
Be aware of the required overhead clearance at all times.
The carry can is carried inside the hopper during travel. As a result, you must allow adequate room
in the hopper for the carry can during travel.
Never close the top door with the carry can inside the hopper. Serious damage will result.
To correctly position the arms, do the following:
Perform the Arms Elevated Proximity Switch test (Refer to "Arms Partly Raised Proximity
1.
Switch in Packing Mode (Residential Units Only)" on page 35).
Raise the arms until they rest on the rubber bump stops (see Figure 4-8).
2.
Retract the forks until the carry can is in the hopper and the Arm not Stowed indicator light turns
3.
green.
: The carry can will be upside down and horizontal inside the hopper.
N
OTE
Turn off the hydraulic pump to reduce the engine load between stops (see Pump Switch on
4.
page 57).
Exhaust Regeneration Process
To get more details about exhaust regeneration process, please refer to the chassis manufacturer's
documentation.
: During the exhaust regeneration process, the operator must raise the arms until they rest on
N
OTE
the rubber bump stops. Failure to do so will cause damage that are not covered by warranty.
Advertisement
Table of Contents
