Table of Contents
Advertisement
Safety while Using the Packing System
Warning!
Always keep the warning lights and/or four-way flashers on when collecting refuse.
Danger!
Never attempt to reach inside the hopper area when either the packer blade or the arms
are in motion. Severe injury or death may occur.
Warning!
Wear protective safety equipment (e.g. safety glasses and gloves) when you are working
close to the hopper area.
Warning!
Always apply the lockout/tagout procedure before entering the hopper area. See Locking
Out and Tagging Out the Vehicle on page 38
Packer Not Working?
If the packer does not cycle:
Read warning message on the display monitor. Refer to Table 1 in chapter 3 for a list of solutions.
1.
Ensure the hydraulic system is engaged.
2.
Pump switch on the control panel must be green-lighted (see Figure 3-14).
Check the emergency red button (see Figure 3-24).
3.
Pull it up if it has been pushed down.
Press the yellow button to ensure the packer is completely retracted (see Figure 3-26).
4.
Check around the packer for any obstruction preventing it from moving freely.
5.
Warning!
Always apply the lockout/tagout procedure before entering the hopper area. See Locking
Out and Tagging Out the Vehicle on page 38.
Check fuses and breakers in the console as well as the fuse located next to the battery box.
6.
Report your findings to the maintenance personnel.
7.
Operating the W
™ 89
ITTKE
Advertisement
Table of Contents
