Packer Blade Position - Tailgate Ajar; Arms Partly Raised Proximity Switch In Packing Mode (Residential Units Only) - Wittke StRLight Operator's Manual

Packer Blade Position - Tailgate Ajar

Successful completion of this test ensures that the packer blade will not complete a full eject cycle
when the tailgate is not completely open.
For this test, proceed as follows:
Push the Tailgate Up button on the control panel until the message "Buzzer: Tailgate Unlocked"
1.
appears on the multiplex display screen and the buzzer inside the cab sounds.
: The backup alarm also sounds when the tailgate is unlocked.
N
OTE
Caution! Ensure body is completely empty prior to conducting this test.
Caution! Check for sufficient clearance behind the vehicle.
Press the Pack push button (green) on the control panel. This function should be inoperative.
2.
If the packing function is still operative with the tailgate ajar, the fully open tailgate proximity
3.
switch may need to be adjusted or replaced. Refer to the Limit and Proximity Switches section in
the Maintenance Manual.
Arms Partly Raised Proximity Switch in Packing Mode
(Residential Units Only)
Successful completion of this test ensures that no container will be accidentally packed when in the
hopper.
For this test, proceed as follows:
Raise the front loader arms until the forks are above the windshield.
1.
Press the Pack push button on the control panel. The packer blade should be disabled.
2.
If the packer blade is not disabled, the Arms Partly Raised proximity switch (located on the right
3.
side of the arm tube) may need to be adjusted or replaced. Refer to the Limit and Proximity
Switches section in the Maintenance Manual.
The Arms Up function is disabled if the packer blade is not in its "home" position.
I :
MPORTANT
Safety 35