Yamaha VMX12H Supplementary Service Manual page 285

INSTALLATION
When installing the swingarm, reverse the re-
moval steps. Note the following points.
1. Lubricate:
Bearing
seals
Lithium Base Waterproof Wheel
Bearing Grease
2. Install:
Swingarm
Pivot shafts
3.
Tighten:
Pivot shafts
By the following tightening steps.
Pivot shaft tightening steps:
the pivot shaft (left)
cation,
Pivot Shaft (Left):
100 Nm (10.0
the pivot shaft (right)
contacts the collar
Pivot Shaft (Right):
6 Nm (0.6
nut (right pivot shaft)
cation.
Nut (Right Pivot Shaft):
100 Nm (10.0
the lock washer tab
flat.
4. Apply:
(Quick Gasket@)
To the mating surfaces of both case halves.
5, Install:
.
Final gear assembly
Nuts (Final Gear Case):
42 Nm (4.2
6. Check:
(side play)
Swingarm (vertical movement)
Refer to " FREE PLAY INSPECTION"
section,
I
to specifi-
72
until
kg, 4.3
to
72
along the nut
30
6-46