Yamaha VMX12H Supplementary Service Manual page 198

ENGINE ASSEMBLY AND ADJUSTMENT
Tighten the cap bolts.
NOTE:
First tighten the No. 3, 1 and 4 cap bolts in
that order, then the No. 2 cap bolts,
Camshaft Cap:
10 Nm (1.0
5.
Install:
Cam chain sprockets
By the following installation steps.
:am chain sprockets installationsteps:
the mark
with the stationary pointer
32 mm wrench.
case cover use
turn the flywheel installing bolt.
Rotating the bolt may loosen it, causing the
rotor to fall out.
not turn the crankshaft during the
sprocket installation.
the cam chain onto the intake
sprocket.
Install the sprocket with the punched mark
"REAR" facing outward and finger-tighten
the sprocket bolts.
Align the "IN" mark
the thread hole on the camshaft.
the intake camshaft to align the
timing mark small hole) on the cam-
shaft with the embossed match mark
the camshaft cap
7.2
on the flywheel
on the crank-
hole on the sprocket
@
on
3-74