Yamaha VMX12H Supplementary Service Manual page 182

I -
/ - -
ENGINE ASSEMBLY AND ADJUSTMENT
8.
Install:
shaft assembly
1
lever
Shift lever 2
TRANSMISSION
1. Install:
Plane bearings
Identify each plane bearing position very carfuly
so that it can be reinstalled in i t s original palce.
2.
Install:
*Main axle assembly
Drive axle assembly
NOTE:
the bearing circlips
lower crankcase positioning grooves.
Position the bearing pin
3.
Install:
Middle driven pinion gear assembly
NOTE:
careful not to damage the O-ring
installation.
arrow mark on the bearing housing
points to the upper crankcase.
4. Install:
rod support bearing
NOTE:
the bearing pin
hole.
the oil seal
.
bear i ng
Lightly apply grease to the oil seal lips.
shaft)
completely into
as shown.
during
into the crankcase
snugly against the
3-58