FINAL GEAR OIL LEVEL INSPECTION
OIL REPLACEMENT
CHASSIS
FINAL GEAR OIL LEVEL INSPECTION
FINAL GEAR OIL REPLACEMENT
Defective
valves, cylinder head
Same as without oil
gasket or piston is
Inspect cylinder head,
valve surfaces, or
Above maximum level
piston crown for
carbon deposits.
NOTE:
The difference between the highest and
lowest cylinder compression readings must
not vary more than the specified value.
Difference Between Each Cylinder:
Less than 98
1. Inspect:
gear oil level
Oil
level low
Add sufficient oil.
By the following inspection steps.
Final gear oil level visual inspection steps:
the motorcycle on a level area and
place on i t s centerstand.
the oil filler cap
check the oil level. Correct oil
level
should be a t the brim of the hole.
the oil level is low, add sufficient oil.
the oil filler cap to specification.
Oil Filler Cap (Final Gear):
23
Nm
(2.3
1. Place a receptacle under the final gear case.
2.
Remove:
filler cap
plug
Drain the oil.
possible.
(1
14 psi)
.
17
2-18