Gps Receiver Setting (Gps Process Setting) - JRC JMA-5312-6 Instruction Manual

3.4.20 GPS Receiver Setting (GPS Process Setting)

Set to a JRC's GPS receiver.
This setting is enabled when a JRC's GPS is connected to the GPS connector of processor unit.
[I] Own Ship's position setting (Position)
Procedures 1. Press the [RADAR MENU] key twice, and then perform the following
2. Enter the own ship's position in the numeric value input menu.
3. Press the [9] key to send the setting value to GPS receiver.
[Ⅱ] Satellite exclusion setting (Exclusion)
Procedures 1. Press the [RADAR MENU] key twice, and then perform the following
2. Enter the satellite exclusion number in the numeric value input menu.
3. Press the [9] key to send the setting value to GPS receiver.
menu open procedure to open the Position menu.
4. NAV equipment Setting
→ 4. GPS Setting
For the input method on the latitude / longitude input screen, see Section 3.3.4.
menu open procedure to open the Exclusion menu.
4. NAV Equipment Setting
→ 4. GPS Setting
For the input method on the numeric value input screen, see Section 3.3.4.
→ 1. GPS Process Setting
→ 1. Position
→ 1. GPS Process Setting
→ 2. Exclusion
3-39