Ais Operation; 5.3.1 Restrictions; Setting Ais Display Function (Ais Function) - JRC JMA-5312-6 Instruction Manual

5.3

AIS OPERATION

AIS Process Unit (option) is necessary.

5.3.1 Restrictions

The following restrictions are placed on use of the AIS function.
•
The AIS function is unavailable in the following cases:
a) MAN or
b) The current offset (Set/Drift Setting) is set while LOG or 2AXW is selected for the speed
sensor.
c) The GPS geodetic system is used except WGS-84.
•
LOG or 2AXW cannot be selected for the speed sensor in the following case:
The AIS function is turned on and the current offset (Set/Drift Setting) is selected.
•
MAN cannot be selected for the speed sensor in the following case:
The AIS function is On.
•
Current offset (Set/Drift Setting) cannot be turned On in the following case:
LOG or 2AXW is selected for the speed sensor while the AIS function is on.

5.3.2 Setting AIS Display Function (AIS Function)

Attention
When the AIS function is set to Off, the AIS display
function is turned off and AIS symbols are no longer
displayed.
Once the AIS display function is set to Off, it is not
automatically switched to On even if a dangerous
target exists.
Procedures 1
REF. is selected for the speed sensor.
Put the cursor on the AIS On / Off (TT / AIS information ⑧ on page
2-23), and press the [ENT] key.
The received AIS information will be shown on the radar display.
5-31