JRC JMA-5312-6 Instruction Manual page 361

[III] Receive Port Setting (RX Port)
Select ports for receiving signals from sensors.
There are two methods for receiving signals: specifying a port for each sensor, or using the automatic
recognition function without specifying ports.
Procedures 1. Open the Serviceman Menu.
2. Open the RX Port menu by performing the following menu operation.
3. Select ports for each sensor.
Available sensor signals
Heading, Speed, AIS, GPS, DLOG, Alarm, Depth, Temperature, Wind, Current, ROT,
RSA, Time Zone, Date/Time
Available ports
Behavior pattern of selectable ports
2. Installation Menu
→ 9. Next
→ 5. LAN Port Setting
When the automatic recognition function is used
When ports are specified : User Setting, Serial, LAN, LAN(GPS),
AUTO
User Setting
Own
LAN
LAN(GPS)
LAN(Ship's Clock)
i. In order to set "3.14.1 Receive Port Setting (RX Port)", select
in advance.
ii. LAN(GPS) and LAN(Ship's Clock)
Time Zone and Date/Time.
7-28
→ 2. RX Port
LAN(Ship's Clock)
: The system use data from JRC-LAN preferentially
: The system use the port selected by "3.14.1 Receive
Port Setting (RX Port)". The system use data from
JRC-LAN or sensor connected directly.
: The system use data from sensor connected to the
system directly.
: The system use data from JRC-LAN.
: The system use GPS data from GPS connected to
ii
JRC-LAN .
: The system use ship's clock data from ship's clock
ii
connected to JRC-LAN .
are selectable signals for
7.2 Settings
: AUTO
i
User Setting
7