Gps Receiver Setting - JRC JMA-5312-6HS Installation Manual

3. Press the [2] key.
The correction set numeric value input menu will appear.
4. Input the correction value.
Press the + or - button to select south and north for latitude or the east and west
for longitude.
For how to input numeric data on the numeric value input screen, see Instruction manual
Section 3.3.4.
4.19

GPS RECEIVER SETTING

Set to a JRC's GPS receiver.
This setting is enabled when a JRC's GPS is connected to the GPS connector of processor unit.
[I] Own Ship's position setting (Position)
Procedures 1. Press the [RADAR MENU] key twice, and then perform the following
menu open procedure to open the Position menu.
2. Enter the own ship's position in the numeric value input menu.
For the input method on the latitude / longitude input screen, see Instruction manual
Section 3.3.4.
3. Press the [9] key to send the setting value to GPS receiver.
[Ⅱ] Satellite exclusion setting (Exclusion)
Procedures 1. Press the [RADAR MENU] key twice, and then perform the following
menu open procedure to open the Exclusion menu.
2. Enter the satellite exclusion number in the numeric value input menu.
For the input method on the numeric value input screen, see Instruction manual Section
3.3.4.
3. Press the [9] key to send the setting value to GPS receiver.
All manuals and user guides at all-guides.com
4. NAV equipment Setting
→ 4. GPS Setting
→ 1. GPS Process Setting
→ 1. Position
4. NAV Equipment Setting
→ 4. GPS Setting
→ 1. GPS Process Setting
→ 2. Exclusion
4-
20
4